GLK 350 4MATIC (204.987) V6-3.5L (272.971) (2010)
Component Identification
5
Mount clamping device part 2 (02) on the clamping device part 1 (01) with clamp screws (2).
Tighten clamp screws (2) by hand until the clamping device part 2 (02) abuts the front spring (1).
Use clamp screws (2) from 204 589 00 63 00 for model 204.0/2, 207, 212 with code 482, 485 or 677.
Use clamp screws (2) from 204 589 02 63 00 for model 204.9, 212 with code 486 or 488.
6
Twist front spring (1) so that the start of the spring coil reaches position "H" (arrow).
7
Clamp front spring (1) until the clamping position "L5" is reached.
8
Tighten clamp screws (2) with tightening torque (5 ).
It is essential to maintain the tightening torque, otherwise the thrust bearing (5) will be damaged or the front spring (1) can twist when clamping
Component Identification
9
Clamp front spring (1) with tensioning device (06) until the clamping position "L3" is reached.
10
Detach nut from piston rod.
Counterhold piston rod with Torx TX50
11
Move out suspension strut (6).
12
Move tensioning device (06) into removal position "L1".
13
Remove front spring (1) and head bearing (7).