ML 320 (163.154) V6-3.2L (112.942) (1998)
Remove/Install
1
Open glove compartment lid (1)
2
Unclip glove compartment lamp (E13/1) and disconnect connector
3
Unscrew bolt (2)
-
Torx bit set: See Special Tools below.
4
Remove upper spreading rivets (5) from glove compartment (3)
NOTE: Press pressure pin approx. 4 mm upward and remove spreading rivet downward.
5
Pull glove compartment (3) out of instrument panel (4)
6
Install in the reverse order
NOTE: Align upper edge of glove compartment lid (1) in relation to instrument panel (4).
Special Tools
Torx Bit Set P/N # 000 589 01 10 00