ML 320 (163.154) V6-3.2L (112.942) (1998)
Note:
Replacement of the lift gate is permissible if there is deterioration of the sheet metal of more than 1.5 mm or rust through damage over a length
of 3cm in the area of the handle cutout (Figure 4)
Workshop Equipment
Parts Information
Note:
The following allowable labor operations should be used when submitting a warranty claim for this repair. This information has been generated on
August 18, 2008. Please refer to Netstar --> Star Teklnfo --> Star Time for the most current labor time allowance.
In case of Warranty, use the table.
Technical Service Bulletin # T-98_10-18B
Date: 080813
Body - Paint Damaged On Liftgate
Date: August 13, 2008
Order No.: T-B-98.10/18b
Supersedes: T-B-98.10/18a dated Feb. 22, 2008