ML 320 (163.154) V6-3.2L (112.942) (1998)
Sunroof / Moonroof Motor: Service and Repair
AR77.20-P-3010GH Remove/Install Sliding/Pop-Up Roof Motor
Removing And Installing Sliding/Pop-up Roof Motor
- with CODE (414a) Glass electric tilting/sliding roof
Removal, installation
1
Remove front dome lamp (1)
2
Pull edge guard (2) off of sliding/pop-up roof cutout
3
Disconnect connector (M12x1) from sliding/pop-up roof drive assembly (M12)
4
Unscrew screws (4) from sliding/pop-up roof drive assembly (M12)
-
Screw for sliding roof drive on sliding/pop-up roof frame:
-
Torx = 4 Nm
-
Alien wrench = 4 Nm
NOTE: Pull headliner down slightly. The screws are located behind the headliner.
5
Remove sliding/pop-up roof drive assembly (M12)
6
Install in opposite order
7
Synchronize sliding/pop-up roof
NOTE: Open sliding/pop-up roof at top and hold switch pressed down. Sliding/pop-up roof mechanism moves to end position, moves back 1/4
turn and stops