mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

Electronic Stability Program (ESP)|Page 7054 > < Electronic Stability Program (ESP)|Page 7052
Page 4
background image

-

Automatic transmission selector lever

in position "N"

-

Towing speed

max. 50 km/h

-

Towing distance with automatic transmission

max.50 km

Do not exceed the maximum towing speed or maximum towing distance as this may damage the transmission.

One axle raised:

-

Ignition OFF

Otherwise ETS/ESP

control is active!

Disconnect the propeller shafts at the flange before towing the vehicle for long distances or if the transmission is damaged.

Tow-start

It is not possible to emergency-start the engine by towing the vehicle.

Testing and repair work

-

The brake system is bled and the brake fluid is changed in the same way as with vehicles with ABS. It is not necessary to bleed the ETS/ESP
system or carry out a special bleeding procedure.

Using roller dynamometers

Brake test stand

-

Checking parking brake

Ignition OFF
otherwise ETS/ESP
control is active!

Functional test stand or output dynamometer and testing the speedometer

-

Only possible on 2-axle roller dynamometers

Vehicle has permanent all-wheel drive.

3 differentials are used which can be damaged by large and above all sustained differences in speed.

Treatment of ETS/ESP components on vehicles involved in an accident

If, because of the extent of the damage to the vehicle or the position and external appearance of the hydraulic unit after the accident, it is obvious that the
hydraulic unit has sustained a heavy shock, it must be renewed.

Indications of this are e.g.:

-

Hydraulic lines kinked

-

Connections on hydraulic unit leaking

-

Cables or plug connections damaged

-

Metal block of hydraulic unit shows signs of damage

-

Hydraulic unit detached from its bracket and cannot be easily reinstalled

Even if none of these are applicable the system must still be subjected to a rigorous function test. Solenoid valves and pumps must be checked using the
appropriate test procedures of the handheld tester.

GF42.35-P-4500-01C Function of ETS Control Module

GF42.35-P-4500-01C Function Of ETS Control Module

Electronic Stability Program (ESP)|Page 7054 > < Electronic Stability Program (ESP)|Page 7052