ML 430 (163.172) V8-4.3L (113.942) (2000)
Shown On Engine 112
Remove/Install
1
Remove engine trim panel
2
Remove viscous fan (4)
NOTE: Right-hand thread!
3
Remove fan shroud (5).
NOTE:
-
Only Engine 112.942 /970.
-
Unscrew bolts (8) at bottom of fan shroud
4
Remove air guide (9)
NOTE: Only Engine 113.942.
5
Drain and collect engine oil.
6
Unscrew nuts (7) at front suspension carrier
NOTE: Before unbolting the left engine mount, press oil line of power steering out of fixture.
7
Remove resonance pipe (3) and resonance body (2).
NOTE:
-
Do not damage the plastic strap.
-
The resonance pipe is attached at the rear at the intake manifold with a plastic plate.
-
Disconnect connector of hot film mass air flow sensor (HFM) and unscrew resonance pipe at cylinder head cover.
8
Fit on engine supporting frame.
9
Raise engine
NOTE:
-
Ensure that the rear of the engine does not touch the body!
-
Do not overstretch coolant lines and engine ground strap/body (W11/5), if necessary remove engine ground strap/body (W11/5).
10
Unbolt bottom part of oil pan (6)
11
Remove bottom part of oil pan (6)
NOTE: Installation: Clean sealing surfaces, apply sealing compound to the sealing surfaces with a bead of 2.0 mm (± 0.5 mm)! The sealant
must be applied within 10 minutes! The silicone bead must not be spread!