mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

Digital Tele Aid(R) - Control Module Upgrade|Page 11391 > < Digital Tele Aid(R) - Control Module Upgrade|Page 11389
Page 2
background image

Observe the status of the switches. If problem is intermittent, then manipulate switch and/or wiring in order to provoke failure. If any of the Actual
Values register as OPERATED or ON, while the trunk is closed, then further inspection is required of the trunk latch assembly.

III.

DIAGNOSIS USING WIS DOCUMENTATION:

There are many components in the anti-theft alarm (ATA) system connected with the TeleAid control unit. There is the case where any one of these
components could become faulty and cause an unwarranted AAN signal to the TeleAid control unit. The following WIS documentation lists information
regarding the anti-theft alarm (ATA) system in different models. These control units can be found in WIS under group 80.50: Anti-theft alarm system
(ATA), interior motion sensor/Tow sensor for all models. Here are more specific documents found in group 80.50:

IV.

SUPPLEMENT FOR RDU DIAGNOSIS

In all of these documents, it is possible to find the trunk latch/button. Not only is this a component of the ATA, but it also responsible for the triggering
of a Remote Door Unlock. The table lists all the trunk latch/button respective to all models taken from the WIS documentation. The trunk latch/button
should be the FIRST component diagnosed. Use this in RDU cases:

V.

DETECTING DISCRETE RDU AND AAN SIGNALS FROM TELEAID CONNECTOR:

Note

The following method only apples to vehicles with TeleAid 2 units. All vehicles with a CP (e.g. 211) only transmit RDU and AAN signals via CAN).

The table describes the type of signals used to communicate the RDU and AAN signals to the TeleAid control unit:

^

If the vehicle supports a discrete signal for AAN, a 12V signal to pin 32 on the TeleAid control unit will trigger a call for an alarm notification.

^

If the vehicle supports a discrete signal for RDU, a 0V signal to pin 41 on the TeleAid control unit will trigger a call for a remote door unlock
request.

Some models support CAN messages to the TeleAid control unit for both RDU and AAN.

Digital Tele Aid(R) - Control Module Upgrade|Page 11391 > < Digital Tele Aid(R) - Control Module Upgrade|Page 11389