ML 500 (163.175) V8-5.0L (113.965) (2003)
6
Remove housing (1)
NOTE:
-
Set selector lever to position N
-
Installation: As of 01.09.01, ensure that air duct is installed tightly.
7
Install in the reverse order
AR68.20-P-2020GI Remove/Install Rear Center Console
AR68.20-P-2020GI Remove/Install Rear Center Console
- Models 163.154/174 #A as of 289565
- Models 163.157/175 (all)
Remove/Install
1
Remove armrest lid (1)
2
Remove stowage box in the center console
NOTE: Press the center pin approx. 4 mm downwards, then remove the rivet upwards
3
Remove screws (2) on the cup holder
4
Remove inner part of ashtray
5
Remove ashtray trim (3)
CAUTION: Risk of breaking the clips (4)
NOTE: Loosen clips (4) and pull back the lower edge of the cover and remove upwards
6
Remove screws (5)
7
Unclip rear center console (6) above (arrows)
-
Long wedge: See Special Tools below.
8
Remove rear center console (6) from the center console
9
Disconnect plug from control module of rear control panel and ashtray
NOTE: Disconnect plug of the rear ashtray from ashtray housing
10
Install in the reverse order