ML 500 (163.175) V8-5.0L (113.965) (2003)
/v8-5.0l_(113.965)/Page-2316021.png)
LSHHK2
Oxygen (O2) sensor 2 Warm Up after Three Way Catalytic converter
LSHVK1
Oxygen (O2) sensor 1 Warm Up before Three Way Catalytic converter
LSHVK2
Oxygen (O2) sensor 2 Warm Up before Three Way Catalytic converter
LTF-0
Signal air temperature sensor, as of 11/99
LTF-1
Ground air temperature sensor, as of 11/99
LVM
Air supply module
LWS
Steering angle sensor Signal
M BLU
ESP stop lamp suppression
M FH
Ground vehicle-level sensor rear, as of 11/99
M FV
Ground vehicle-level sensor front, as of 11/99
M IL
Ground actual value actuator left, as of 11/99
M IR
Ground actual value actuator right, as of 11/99
Manuel Test
Manual Test, as of 11/99
MC
Ground Mixture Control
MH
Mixture Control
Mic +
Microfon (+), as of 11/99
Mic GND
Microfon (-), as of 11/99
MID
Brake booster (BAS) potentiometer
MK1L
Engine terminal 1 left side, as of 11/99
MK1R
Engine terminal 1 right side, as of 11/99
MK2L
Engine terminal 2 left side, as of 11/99
MK2R
Engine terminal 2 right side, as of 11/99
+MV
Power supply solenoid valve, as of 11/99
MMV
Ground solenoid valve
MOK0
Power supply (+5V) oil sensor, as of 11/99
MOK1
Signal oil sensor, as of 11/99
MOK2
Ground oil sensor, as of 11/99
MPX
Multiplexer
MRA
Relay motor output
MRU
Relay motor voltage
MSG
Signal Signal motor control unit, as of 11/99
MTR-CCW
Shift Motor Output (Low to High Range)
MTR-CW
Shift Motor Output (High to Low Range)
MV 1
Solenoid valve (BAS) 1
MV1-1
Injection control "high-side" cylinder 2 and 5, as of 11/99
MV11-0
Injection control "low-side" cylinder 2, as of 11/99
MV12-0
Injection control "high-side" cylinder 5, as of 11/99
MV 2
Solenoid valve (BAS) 2
MV2-1
Injection control "high-side" cylinder 1, 3 and 4, as of 11/99
MV21-0
Injection control "low-side" cylinder 1, as of 11/99
MV22-0
Injection control "low-side" cylinder 4, as of 11/99
MV23-0
Injection control "low-side" cylinder 3, as of 11/99
N2
Angular Speed N2
N3
Angular Speed N3
NC
Not used, as of 11/99
NSEG
Angular speed signal
NSL
Fog tail light, as of 11/99
NTC
Temperature-dependend resistor
NTC, i, o
Signal input NTC control, as of 11/99
NWHG
Ground NOWE sensor, up to 11/99
Signal NOWE sensor, up to 11/99
Hallsensor camshaft, as of 11/99
NWS
Camshaft positioner, as of 11/99
OPEN
Brake booster (BAS) open signal
P
"Park"-Position
Parking (Ignition lock), as of 11/99
P/N
Signal parking/neutral recognition, as of 11/99
PML -
Magnetic valve parametric stearing (-), as of 11/99
PML +
Magnetic valve parametric stearing (+), as of 11/99
POS 1
Position Encoder #1 Input
POS 2
Position Encoder #2 Input
POS 3
Position Encoder #3 Input
POS 4
Position Encoder #4 Input
PTC 1, o, ms
Signal output PTC Heating-relay Pos.1, as of 11/99
PTC 2, o, ms
Signal output PTC Heating-relay Pos.2, as of 11/99
PTC 2+3, o, ms
Signal output PTC Heating-relay Pos.2 + 3, as of 11/99
