ML 55 AMG (163.174) V8-5.5L (113.981) (2001)
Oil Pan: Removal and Replacement
AR01.45-P-7500FB Remove/Install Oil Pan
Remove/install oil pan
Shown On Engine 112
Remove/Install
1
Remove oil pan bottom section (1)
2
Disconnect electrical line at oil sensor (oil level, temperature and quality) (B40)
NOTE: Remove cable strap at oil pipe.
3
Remove oil pipe (2) from dipstick.
NOTE: Installation: Replace sealing ring!
4
Remove oil pan top section (3)
-
At the same time take out oil pan in direction of travel toward front, if necessary rotate the crankshaft a little.
NOTE:
-
Installation: Observe different bolt length and bolt diameter: Bolt diagram of oil pan.
-
Information on application of sealant to oil pan.
5
Install in the reverse order
6
Read diagnostic trouble code memory and erase.
-
Stored faults which can result from removed lines or a simulation due to installation or test work, have to be processed and erased in the fault
memories after completing the work.
DANGER:
-
Risk of accident. Accidents may result if the vehicle starts off unintentionally with the engine running. Risk of injury as working
around the engine during start-up or while running may result in contusions and burns.
-
Secure vehicle to prevent it from moving. Wear closed and snug-fitting work clothes. Do not grasp hot or rotating parts.
7
Run engine and inspect for leaks.
AR01.45-P-7555VE Remove/Install Bottom Part of Oil Pan
Remove/Install Bottom Part Of Oil Pan