R 350 4MATIC (251.165) V6-3.5L (272.967) (2006)
Antenna Control Module: Service and Repair
AR65.10-P-9080-04RT Prepare Antenna Module Cover For Installation
AR65.10-P-9080-04RT Prepare Antenna Module Cover For Installation
Commercially Available Tools
Workshop Equipment
Repair Materials
Wear cotton gloves. Ensure that no fingerprints are present in the area of the gluing surface (area E). To prevent adhesion problems when glazing, keep
gluing surface (area E) free of dust, oil, grease, wax, dirt residues and other anti-adhesive components.
1. Check antenna module cover (1) for damage.
2. Install suction cup on outside of antenna module cover (1) and place antenna module cover (1) (with inside facing upwards) on suitable support.
3. Apply glass activator to gluing surface (area E) on antenna module cover (1) with part of the paper towel and wipe with remaining paper towel.
Apply glass activator only to black gluing surface (area E). If glass activator gets onto transparent areas wipe off immediately. Allow glass
activator to dry completely.
4. Apply glass primer to gluing surface (area E) on antenna module cover (1) using application rod provided and allow to air-dry completely (airing
time at least 10 minutes).