R 350 4MATIC (251.165) V6-3.5L (272.967) (2006)
/v6-3.5l_(272.967)/Page-3506001.png)
Antenna Control Module: Service and Repair
AR65.10-P-9080-01RT Cut Out Antenna Module Cover With Cutting Knife
AR65.10-P-9080-01RT Cut Out Antenna Module Cover With Cutting Knife
Special Tools
Workshop Equipment
1. Clamp blade (4) straight into pneumatic tool (component of cutting tool).
Blade WK1X is additionally required (no component of cutting tool).
2. Moisten whetstone and sharpen both sides of blade with machine switched on.
3. Clamp guide (5) straight into pneumatic tool (component of cutting tool).
4. Lift seal (2) in area B and install long wedge (3).
Always hold gasket (4) away from blade (4) with long wedge (3).
5. Cut adhesive bead on antenna module cover (1) from outside in areas A, C and D while holding blade (4) to antenna module cover as near as
possible.
6. Install suction cup and lift off antenna module cover (1).
AR65.10-P-9080-02RT Prepare Antenna Module Cover Body Flange For Installation.
AR65.10-P-9080-02RT Prepare Antenna Module Cover Body Flange For Installation
Commercially Available Tools
