R 350 4MATIC (251.165) V6-3.5L (272.967) (2006)
The middle clip serves as a spacer; it is not attached to anything.
3.
Install protective cap on rear engine support mounting screw (A, Figure 3).
C. Repair Starter Wiring Harness Corrugated Tube
1.
Cut open a new 5 cm long corrugated tube (A, Figure 4) lengthwise and install over existing tube (B) in damaged area (circled).
2.
Repair paint section on engine support if damaged.
3.
Perform Subject B: Fasten starter wiring harness to oil dipstick guide tube using clips and install protective cap on rear engine support mounting
screw.
D. Replace Starter Wiring Harness