R 350 4MATIC (251.165) V6-3.5L (272.967) (2006)
6.
Cut wire ties and disconnect starter wiring harness (A, Figure 8) from front prefuse F32 (B).
7.
Remove starter wiring harness from vehicle; install new wiring harness in reverse order.
^
Torque bolts on alternator and starter to 15 Nm.
^
Secure new harness with cable ties.
8.
Assemble in reverse order.
9.
Repair paint section on engine support if damaged.
10.
Perform Subject B: Fasten starter wiring harness to oil dipstick guide tube using clips and install protective cap on rear engine support mounting
screw.
11.
Perform basic programming; refer to WIS document AR00.19-P-0200RT.