S 320 LWB (140.033) L6-3.2L (104.994) (1995)
Shifter A/T: Service and Repair
Remove/install floor selector
Remove/install
1
Remove shift rod at intermediate lever (97)
NOTE: Remove clip retainer.
-
If adjusting: Adjust shift rod.
2
Remove center console
3
Remove insulation mat
-
Model 163
4
Unscrew hexagon socket bolts (40)
5
Disconnect couplings
NOTE: From gear identification switch (S16/10), reverse lamp switch (S16/10s2) and R/P lock electromagnetic actuator (Y66/1).
6
Remove floor selector
NOTE:
-
Disassemble and assemble floor shift according to condition.
-
Installation: Check gasket (39) for correct installed position and condition, replace if necessary.
7
Install in the reverse order
NOTE: After installing the floor shift, read out fault code using HHT and erase, refer to DM Chassis Volume 1 - Index 0.