S 320 SWB (140.032) L6-3.2L (104.994) (1994)
/l6-3.2l_(104.994)/Page-1926001.png)
Front Steering Knuckle: Service and Repair
1. Raise and support vehicle, then remove front wheel.
2. Disconnect ABS wheel speed sensor, then remove plug connector from bracket.
3. On vehicles equipped with ADS, remove wheel acceleration sensor.
4. Remove brake caliper and brake disc.
5. Remove front hub, then brake backing plate.
6. Remove torsion link bar from steering knuckle.
7. Using special extractor tool 140 589 09 33 00, or equivalent, and special thrust piece tool 140 589 24 63 00, or equivalent, press support joint
from steering knuckle.
8. Disconnect steering knuckle from upper control arm and remove steering knuckle.
9. Reverse procedure to install.
