S 350 (140.134) L6-3.5L DSL Turbo (603.971) (1995)
7.
Insert impact absorber and holder on AMG beam.
8.
Insert preassembled beam into AMG rear skirt and secure with the fasteners provided.
9.
Secure reinforcement and chrome moldings with clips.
10.
Secure trim piece to reinforcement using fasteners provided.
Final assembly
11.
Install rear apron/bumper assembly on vehicle without fully tightening mounting bolts.
12.
Inspect alignment of assembly and adjust if necessary (A 5 mm, Figure 15).
13.
Tighten mounting bolts.
E. Painting Recommendations (Model 202)
Refer to sections 1.19 and 1.20 of the Refinishing Manual, as well as S.I. 98/34.
Model 124, 129, 140, 201
Group: 88