S 350 (140.134) L6-3.5L DSL Turbo (603.971) (1995)
The job numbers included in the following procedures refer to Service Microfiche:
Brakes
Models 129, 140, 202, 210
Groups 42, 43
Body-assembly jobs I
Model 129
Groups 67, 68, 72
Body-assembly jobs I
Model 140
Groups 67, 68
Remove Parking Brake Pedal and Bracket
MODELS 129, 140
Release parking brake front cable from automatic adjuster located above rear driveshaft
AR42.20-0510A (A6)
1.
Raise vehicle on lift.
2.
Remove body stiffening cross-brace.
3.
Unhook exhaust system 0-rings.
4.
Support exhaust system as required.
5.
Remove exhaust heat shields as necessary to gain access to parking brake cable automatic adjuster.
6.
Preload automatic adjuster (92) by rotating hex. socket bolt (g) by approx. 1/2 turn counterclockwise, at the same time pushing rearward (direction
of arrow) until eccentric locks into spring clip (d).
Caution
During reassembly, release automatic adjuster by lifting spring clip (d) with screwdriver.
7.
Remove tensioning spring (94).
8.
Disconnect front parking brake cable (85) by removing retaining bolt (93).
MODEL 129