S 350 (140.134) L6-3.5L DSL Turbo (603.971) (1995)
! WARNING!
Do not use impact driver to compress front axle springs.
3.
Loosen front axle damper Strut at upper strut mounting (6), apply counter hold to piston rod (1, Figure 1).
4.
Lower control arm and damper strut (provide support for control arm).
5.
Install spring travel limiting washer (5) onto piston rod (1) over strut bumper (4, Figure 1).
6.
Reassemble damper strut and front axle spring in reverse sequence.
Note:
Use new self-locking nuts (9) and washers (8, Figure 1) on upper strut mounting. Tightening torque: 60 Nm.
Front fenders
7.
Remove lower body panel from front fenders.