S 500 Coupe (140.070) V8-5.0L (119.980) (1997)
-
To correct the rear angle, insert an additional 2 mm thick spacer between the rear axle and the rubber mount (arrow).
-
A 1 mm thick spacer changes the articulated angle by approximately 0.25-0.33°
NOTE:
^
Spacers are available as spare parts in thicknesses of 1 mm-4 mm.
^
When using a 2-5 mm thick spacer, increase the bolt length by 5 mm.
^
If a spacer greater than 5mm is required, check the front rubber mount of the rear axle carrier, for wear, damage or settling, replace if necessary
AR41.10-P-0050-05DA Connect Sections of Propeller Shaft
AR41.10-P-0050-05DA Connect sections of propeller shaft
Component Identification
1
Coat the splined profile with Molykote grease before assembly.
2
Reconnect front and rear sections of propeller shaft. The humps on the front propeller shaft must be between the two humps on the linkage arm
(arrows).
Ensure correct seat of rubber sleeve at large diameter.
Position of propeller shaft without clamp connection
Component Identification
Position of propeller shaft with clamp connection