S 500 Coupe (140.070) V8-5.0L (119.980) (1997)
Flex Plate: Removal and Replacement
RA03001194100X Remove/Install Driven Plates
RA03001194100X Remove/Install Driven Plates
Removal and Installation
Preparation
-
Transmission removed.
Overview
-
Install retaining lock for crankshaft/ring gear, remove, refer to Engine.
-
Unbolt position sensor (3) of ignition control unit with bracket (1), bolt on (refer to step 2 below).
-
Unbolt stretch bolts (19), replace ( refer to steps 3 and 4 below).
-
Take off driven plates (17) and (18), fit on.
-
Note installation position and installation order, refer to steps 5 and 6 below.
NOTE:
-
Driven plates and ring gear are balanced individually and can be replaced without balancing.
-
The tapped holes in the crankshaft flange are drilled through.
-
If the bolts are removed and the engine is filled, engine oil flows out of the tapped holes.
Procedures
1. Remove retaining lock for crankshaft/ring gear, install (03-6000).