S 500 Sedan (140.051) V8-5.0L (119.980) (1996)
/v8-5.0l_(119.980)/Page-709001.png)
Oil Filter Housing: Service and Repair
Preparation
-
Viscous fan coupling removed. See: Cooling System
-
Poly V-belt removed. See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair
Removal/Installation:
-
Remove engine compartment panel.
-
Remove generator.
-
Unplug plug connection (10) of oil pressure sensor (11).
-
Unbolt oil pressure sensor (11) and remove with seal (12).
Tighten to: 15 Nm.
-
Unbolt oil pipe (8) of air-oil cooler at oil sump.
-
Unbolt oil lines (7) and (8) of air-to-oil cooler at oil filter (5).
Tighten to: 7 Nm.
-
Replace seals (9).
-
Unbolt oil filter (5) at crankcase.
Tighten to: 25 Nm.
-
Remove oil filter (6) upward.
Installation Note: Clean sealing surfaces.
-
Replace gasket (5a).
-
Install in reverse sequence, observing tightening specifications and the installation note.
-
Check oil level in engine, adjust to correct level.
-
Run engine, check for leaks.
