S 550 (221.171) V8-5.5L (273.961) (2007)
Power Trunk / Liftgate Lock Switch: Technical Service Bulletins
Body - Trunk Lid Valet Lock Retrofit
Date: September 2007
Order No.: P-I-88.50/68
Supersedes:
Group: 88
SUBJECT:
MODEL 221 (equipped with SA code 806)
MODEL YEAR 2007
Trunk Lid Valet Lock Retrofit
A.
PREPARING FOR THE INSTALLATION
1.
Read these installation instructions in their entirety before proceeding.
2.
Unpack and compare the installation parts against the Parts Information list in the parts section of this document.
3.
Remove right side trunk panel and trunk front panel to access rear SAM and battery (refer to WIS: AR68.30-P-4600SX).
4.
Remove paneling on trunk lid interior and remove right side trunk hinge cover (refer to WIS: AR88.50-P-5000SX).
5.
Remove trunk lid lock cylinder panel:
^
Remove two (T20) torx screws from from underside of trunk lid lip (arrows, Figure 1).
^
Pry out cover using plastic wedge
Note:
^
Refer also to WIS: AR88.50-P-5061SX