S 55 AMG (220.173) V8-5.5L (113.982) (2001)
Oil Pan: Removal and Replacement
AR01.45-P-7500I Remove/Install Oil Pan
Remove/install oil pan
Shown On Engine 112
Remove/Install
DANGER:
-
Risk of death. Death may result if vehicle slips or topples from the lifting platform.
-
Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points
specified by the vehicle manufacturer.
CAUTION: See notes on self-locking nuts and bolts.
1
Remove bottom engine compartment paneling
2
Drain and collect engine oil
NOTE: Installation: Replace sealing ring of oil drain plug.
3
Unscrew bolts (3) of front engine mount (4) at front axle carrier.
4
Fit on engine supporting frame.
5
Raise engine
CAUTION:
-
Ensure that the rear of the engine does not touch the body.
-
Do not over-tension coolant lines.
6
Unscrew bolt of steering coupling at bottom of steering gear
NOTE: Installation: Use new bolt and nut.
7
Support front axle carrier with pit or assembly lift and transmission platform.
8
Remove front axle beam
NOTE: Lower front axle beam. Do not disconnect lines of power steering pump.
9 Disconnect electrical line at oil sensor (oil level, temperature and quality) (B40)
10
Remove oil pan bottom section (2)
11
Remove oil pipe (5) of oil dipstick