S 600 (140.057) V12-6.0L (120.982) (1998)
/v12-6.0l_(120.982)/Page-1480006.png)
4. Assemble puller/installer tool with axle shaft flange as shown in the illustration
5. Pull axle shaft flange into bearing
6. Install rear axle shaft, tighten twelve point collared nut to: 320 Nm
-
Secure with Loctite 574, or equivalent, sealing compound
7. Install brake components
8. Install wheel
Wheel Carrier Removed From Vehicle
Wheel Carrier Removed From Vehicle
REMOVAL
1. Remove rear wheel carrier. See: Wheel Hub/Service and Repair
2. Remove flange from bearing as follows: