S 600 (220.176) V12-5.5L Turbo (275.960) (2005)
Suspension Control Module: Service and Repair
AR32.22-P-6000I Remove/Install Air Spring Control Module
Removing and Installing Air Spring Control Module
- except CODE (487) Active body control (ABC)
Shown On Model 220
1
Connect quiescent current retention device
2
Disconnect ground cable from battery
3
Open engine hood and position upright
4
Unlock and remove cover on left fuse box (F1)
5
Pull out locking slide (1a) from both couplings (1) on ADS and suspension control module (N51) as far as the stop in the direction of the arrow
and remove connections.
NOTE: The locking slide is located below the cable entries
6
Remove data bus system connector (2) from ADS and suspension control module
7
Take out ADS and suspension control module upwards out of left fuse box
NOTE: When the control module is replaced it should be calibrated using STAR diagnosis.
8
Install in reverse order.