S 600 (220.176) V12-5.5L Turbo (275.960) (2005)
Suspension Spring ( Coil / Leaf ): Service and Repair
AR32.20-P-0200-06MB Clamping rear spring
- with CODE (979) Special protection version [model 220]
- except CODE (Z04) Light armoring [model 220]
- with CODE (Z07) Top protection [model 221]
Danger!
Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under load
Use only approved tensioning devices; shield off hazard area if necessary. Inspect special tools for damage and proper operation (visual
inspection) Wear protective gloves.
Special Tools
Component Identification
The retaining lugs (arrow) must always engage in the recesses in the upper clamping plate.
Installed state
Component Identification
1
Insert upper clamping plate (01b) into rear spring (73) such that approx. 3 coils remain exposed above.
2
Position lower clamping plate (01c) on spring control arm (72) from below.
3
Insert tensioning device (01a) into clamping plates (01b, 01c) from below through spring control arm (72) and secure to upper clamping plate
(01b).
4
Tension rear spring (73).