S 600 (220.176) V12-5.5L Turbo (275.960) (2005)
/v12-5.5l_turbo_(275.960)/Page-1861002.png)
Do not use an impact wrench.
Removed state
Component Identification
5
Insert rear spring (73) into spring control arm (72).
6
Insert upper clamping plate (01b) into rear spring (73) such that approx. 3 coils remain exposed above.
7
Position lower clamping plate (01c) on spring control arm (72) from below.
8
Insert tensioning device (01a) into clamping plates (01b, 01c) from below through spring control arm (6) and secure to upper clamping plate (01b).
Component Identification
9
Align rear spring (73) with spring control arm (72).
The hole (arrow) in the impression on the spring control arm must be exposed.
10
Tension rear spring (73).
Do not use an impact wrench.
