S 600 (220.176) V12-5.5L Turbo (275.960) (2005)
Wheel Bearing: Procedures
Remove/Install Rear Axle Shaft Flange and Angular Ball Bearing
Shown On Model 220 With Airmatic
Remove/Install
1
Remove rear-axle shaft (37)
2
Remove rear axle brake caliper
NOTE: Hang the brake caliper to one side with a hook.
3
Remove brake disc
4
Remove brake shoes of parking brake
5
Pull out rear axle shaft flange (10) (wheel carrier installed)
CAUTION: Hydraulic extractor tool: only tighten pressure screw of hydraulic auxiliary press to max. 40 Nm.
NOTE: If a firmly attached rear axle shaft flange (10) cannot be pulled out with 40 N, the wheel carrier (7) should be removed and a steady-state
press should be used.
-
Remove wheel carrier.
-
Pull out firmly attached rear axle shaft flange (10) (wheel carrier removed)
6
Check brake caliper dust shield (112c) for damage and replace if necessary
7
Remove locking ring (9)
CAUTION: Installation: Ensure that the circlip (9) is correctly seated in the wheel carrier (7)
8
Pull double-row angular ball bearing (8) out of wheel carrier (7)
9
Pull bearing inner race off rear axle shaft flange (10)
Inspecting
10
Check lateral and radial runout of rear axle shaft flange (10)
-
Permissible lateral runout
-
if test values exceeded, replace rear axle shaft flange
11
Install in the reverse order.