S 600 Coupe (140.076) V12-6.0L (120.982) (1997)
Rear side window
open.
Cover (arrows) on handles (1 and 2)
press off with plastic wedge and screw out screws below (8 mm).
Handles (1 and 2)
remove from roof frame, when installing insert into locating holes and observe installation position.
Rear light (3)
unclip and disconnect electrical connection.
Screw (arrow)
screw out of end fitting on seat belt (5, 17 mm, 35 Nm).
Panelling (4) on roof frame and rear pillar
unclip (7 clips).
Panelling (4)
remove toward front while guiding seat belt end fitting (5) through panelling. Observe installation note.
Before installing clips on roof frame and rear pillar
check and replace damaged clips.
Panelling (4)
install in opposite order; pay attention to proper fit in area of rear shelf, side wall panelling and front of reveal molding.
Function of rear seat belt
check.
Installation note