S 600 Coupe (140.076) V12-6.0L (120.982) (1997)
/v12-6.0l_(120.982)/Page-1760002.png)
-
Insert O-ring in brake booster groove and pay attention to correct seat.
-
Replace circlip (16b)
-
Ensure circlip (16b) is properly positioned.
-
Pay attention to different circlips of manufacturers.
-
Rub a little methylated spirits into front of diaphragm travel sensor (A7/7b1) so that O-ring slides correctly when inserted.
Inspecting
7. Start engine ID Operate brake several times.
8. Switch off engine.
9. Check diaphragm travel sensor for leaks.
-
It should not be possible to hear any air flow noises from the brake booster.
AR43.10-P-0350A Remove/Install Brake Booster
Remove/Install Brake Booster
1. Unscrew fixing (1) of fuel pipes.
2. Pull off rubber seal (2).
3. Remove clips (4) and unscrew nut (5), loosen sound insulation mat (3) on firewall and push away on the engine side.
4. Unscrew bolts (arrows) on firewall.
5. Blank off vacuum line (6) on brake booster (16).
6. Disconnect plug (S11.1) on brake fluid level sensor.
