S 600 Coupe (140.076) V12-6.0L (120.982) (1997)
/v12-6.0l_(120.982)/Page-795002.png)
Detach, attach.
Radiator (4):
Unscrew from condenser (3), screw on.
Radiator (4):
Remove upward, install.
Installation Notes
The securing studs of the radiator must be inserted into the rubber grommets (19) of the bottom cross member when installing.
With new radiator (4):
Set adjusting bar (20) by hand with adjusting screw (21).
To perform this step:
Turn adjusting screw (21) when front cross member (2) installed.
The adjusting bar (20) must be resting slightly pretensioned against the front cross member (2).
Cooling system:
Fill, bleed.
Oil level of automatic transmission:
Check, adjust to correct level.
Cooling system:
Check for leaks.
TIGHTENING TORQUES IN NM
COMMERCIALLY AVAILABLE TOOL
