S 600 Sedan (140.057) V12-6.0L (120.980) (1994)
Engine Block Heater: Technical Service Bulletins
Engine - Block Heater Installation
TO: OUR MERCEDES-BENZ PASSENGER CAR DEALERS
Date: March 1992
Ref. No. MBNA 20/13
SUBJECT:
MODEL 140.057 (600 SEL)
SUBSEQUENT INSTALLATION OF ENGINE BLOCK HEATER
An engine block heater is now available for the above-listed model. The Work Instructions no. 276 describe the installation of the block heater.
Note:
Customers should be advised that installation of a block heater in this model is at the customer's expense.
Work Instructions
Group: 20
Number: 276
SUBJECT:
MODEL 140.057 (600 SEL)
SUBSEQUENT INSTALLATION OF ENGINE BLOCK HEATER
1.
Disconnect and cover battery negative terminal.
2.
Lift vehicle.
3.
Remove front and rear encapsulation panel from below engine.
4.
Remove starter.
5.
Drain engine coolant by first attaching a 14 mm inner diameter, 1600 mm long hose to the drain plug in the engine block and then loosening the
plug. Drain coolant into a suitable container for reuse later.
6.
Remove core plug (on right side of crankcase near cylinder no. 6) with a 22 mm 6-point socket (arrow, Figure 1).