SL 550 (230.471) V8-5.5L (273.965) (2008)
blow.
Component Identification
Removal and insertion tool of the rubber mount: To move out the piston, screw in the pressure screw (010k) of the press (010h) until the piston
has moved out completely.
Due to the short stroke of the press (010h) this process must be repeated approx. 5 times.
To do this, the piston is to be moved back by turning back the pressure screw (010k) and simultaneously tightening the hand wheel (068e). The
spindle of the hand wheel (068e) must always exert a little pressure onto the press (010h) so that the tools cannot fall out.
Component Identification
6
Insert the thrust piece (068d) and press out the rubber mount.
Install
Component Identification
Model 211, 215, 220, 230
7
Replace sleeve (068b) on bracket (068a) by sleeve (0680.
8
Insert rubber mount (6b) into hole in rear axle carrier.
9
Position removal insertion tool with thrust piece (068g) and press (010h) on rear axle carrier.