SL 55 AMG (230.472) V8-5.5L SC (113.995) (2007)
Memory Screen
The measured angles (d, f) and the calculated inclination angle 3 (g) are displayed.
5
Enter articulation angle 3 (g) e.g. 0.08 degrees into data sheet.
Memory screen
The inclination angles are calculated from the differences between the respective angle measurements.
Front articulation angle (1):
Transmission to front propeller shaft
Inclination angle in center (2):
Front propeller shaft to rear propeller shaft
Rear articulation angle (3):
Rear propeller shaft to rear axle differential
If an inclination angle is outside of the tolerance, it must be corrected. All articulation angle differences should be as close as possible to the center of
the relevant tolerance range. A check measurement must be carried out each time the articulation angle is corrected.
AR41.10-P-0085-03P Measure Absolute Angle at Rear Axle Housing
AR41.10-P-0085-03P Measure absolute angle at rear axle housing
Measurement -Angle 4
The vehicle must be on its wheels for the measurement.
All four angles should be measured in succession without interruption.
An angle that has already been measured can be measured a second time if required. To do this, with the Measurement menu displayed, press the
STEP button repeatedly until the display indicates Ready to measure the relevant angle.