SL 55 AMG (230.474) V8-5.5L SC (113.992) (2003)
6)
Install the pulsation damper between the two hose ends and install the hose clamps (Figure 2).
Note:
The pulsation damper can be installed in either direction. The direction of flow through the pulsation damper is not relevant.
7)
Wrap the pulsation damper and the hose clamps with approximately 40 cm (15 inches) of adhesive backed felt (Figure 3).
Note:
The felt wrap is necessary to eliminate chafing points and noise transmission resulting from vibration.
8)
Install suction line with pulsation damper on the SBC hydraulic unit fitting and secure with clamp.
Note:
The suction line must be installed tension free and must not contact the brake lines or the return line.
9)
Remove the service tool clamp installed in step 2.
10)
Bleed the SBC system using STAR Diagnosis.
Note:
STAR Diagnostics with software version 10/2002 or newer must be used.
Parts Information