SL 600 (129.076) V12-6.0L (120.981) (1995)
Brake Caliper: Service and Repair
AR42.10-P-0080AM Remove/Install Rear Axle Brake Caliper
NOTE: For model name/model number cross reference refer to Model Designation Table. See: Application and ID
DANGER
^
Risk of poisoning due to consuming brake fluid.
^
Risk of injury due to brake fluid coming into contact with the skin or eyes.
^
Only pour brake fluid into suitable, appropriately marked containers.
^
Wear protective clothing and safety glasses when handling brake fluid.
Removal
NOTE:
^
Refer to Notes On Brake Fluid.
^
Refer to Notes on Test and Repair Work to brake system.
1. First disconnect brake hose (51) on brake pipe (5) and then on fixed caliper (31).
-
Immediately seal connections with plugs.
-
The brake fluid reservoir must not empty completely.
2. Disconnect rear brake pad wear pad wear sensor (S10/4) at rear brake pad wear sensor connector.
3. Unscrew right rear brake pad wear sensor connector (S10/4x1)
4. Unscrew micro-encapsulated bolts (35) then remove fixed caliper (31) from wheel carrier.
Installation:
5. Install in reverse order, noting the following.
-
Replace micro-encapsulated bolts (35), tighten to:
Model 140: 115 Nm
Models129.05/060/061/063/064/066/067: 50 Nm.
Models129.068/076: 70 Nm
Model 170: 50 Nm
Model 202 except 202.028 with ASR: 50 Nm
Model 202.028 with ASR: 70 Nm
Models208.335/345/347/365/370/435/445/447/465/470: 50 Nm
Models210.00/01/02/03/04/05/070/072/08 except 210.072 with Code 957 (E50 AMG): 50 Nm
Models210.20/21/22/23/24/26/27/270/272/28/60/61/663: 115 Nm