1997 Mercedes SL 600 V12-60L Roll Bar Hydraulic Valve Block Removal/Installation
Roll Bar Hydraulic Valve Block: Service and Repair
Renewing Solenoid Valves
Preceding work:
Remove coupe roof panel
Remove side panel in rear compartment.
Example
Renewing solenoid valve No.9 on valve block (Y55).
New solenoid valve
make ready.
Roll bar
raise.
Connector coupling (1)
disconnect.
Screws (2)
unscrew (tightening torque 7 + 1 Nm).
Solenoid valve (3)
remove in direction of arrow.
NOTE: Insert solenoid valve immediately in the valve block, otherwise installation would be hindered by escaping hydraulic oil.
Installation
in the reverse sequence.
Function and sealing check
perform.