SL 600 (129.076) V12-6.0L (120.983) (1997)
Top ................................................................................................................................................. move to position A with top switch or manual actuation.
Plug connector (S84/3x) ....................................................................................................................................................................... unclip and disconnect
Nuts (1) .................................................................................................................................................................................................................... screw out
Limit switch (S84/3) ..................................................................................................................................................................... remove together with cable
Installation
Install in opposite order
Adjustment
Limit switch (S84/3) should actuate when the upper part (seal) of the top is level with the trunk lid in the retracted state.
Turn screw (2) to right: Limit switch (S84/3) switches later
Turn screw (2) to left: Limit switch (S84/3) switches earlier
Top Locked at Front
Removal, Installation and Adjustment of Limit Switch - Top Locked At Front (only possible with top tester produced by Bara-Electronic)
Preceding work:
Removal of window key on upper wind protector
Removal of trim on upper windshield See: Exterior Moulding / Trim/Service and Repair