SL 600 (129.076) V12-6.0L (120.983) (1997)
/v12-6.0l_(120.983)/Page-174004.png)
Install in opposite order
NOTE: Lay limit switch cable along flexible hydraulic lines
Adjustment
Connect multimeter to plug connector (S84/6x).
Set multimeter to continuity test (acoustic signal).
Adjust limit switch (S84/6) by moving in oblong holes.
Limit switch (S84/6) should switch approx. 100 mm before reaching the uppermost position of the cloth holding brace.
77-443 Remove/Install, Adjust Limit Switch - Top Locked At Front
77-443 Removal, installation and adjustment of limit switch - top locked at front (only possible with top tester produced by Bara- Electronic)
