SL 600 (129.076) V12-6.0L (120.983) (1997)
/v12-6.0l_(120.983)/Page-1454004.png)
Oil pan, automatic transmission
Electrohydraulic controller unit
Housing
Replacement
REMOVAL
1. Place selector lever in position "P"
2. Remove transmission connector shield if equipped, then disconnect 13-pin connector
3. Loosen 13 pin connector guide bush and remove from transmission housing
4. Drain transmission oil by unscrewing oil drain plug
5. Detach oil pan
6. Remove transmission oil filter
7. Unscrew Torx socket head retaining bolts and remove electric hydraulic control module
INSTALLATION
-
Install in reverse order, noting the following information:
