SL 600 (230.476) V12-5.5L Turbo (275.951) (2004)
/v12-5.5l_turbo_(275.951)/Page-2716012.png)
Using hand tools, tap threads into SBC hydraulic unit bores by running self tapping screw (B, Figure 17) into lower bore without mounting bracket
positioned on SBC unit.
Note:
^
In order to avoid breaking the self-tapping screw (B) during installation, the screw (B) must be positioned absolutely straight.
^
Do not use power tools to install self tapping screw.
^
In the event self tapping screw (B) is broken during installation of bracket (A) perform step 18 then continue with campaign (installation of
bracket due to breakage of mounting screw will not be covered under warranty).
^
Remove self tapping screw (B).
^
Position bracket (A) on SBC hydraulic unit, reinstall self tapping screw (B) and torque to 7 Nm.
