SL 600 (230.476) V12-5.5L Turbo (275.951) (2004)
Gap (A-Figure 9) too large.
Procedure:
Check gaps (A-Figure 9) and adjust if necessary.
1.
Perform rain test.
2.
Partially open Vario roof.
3.
Remove seal from A-pillar rail and from Vario roof rail.
Only at corners (left magnified section in Figure 9).
4.
Completely close Vario roof.
5.
Check gap (A-Figure 9).
Without seal
Use feeler gauge.
Nominal dimension: 5...55 mm, if value is not reached:
6.
Correct rail on A-pillar.
Do not adjust seal on Vario roof at side, otherwise gap to C-pillar rail is increased.
7.
Install seal on A-pillar rail and Vario roof rail.
8.
Perform leakage test.
IV. Water Leak In Area of Roof Paneling
IV.
Penetration by water into roof paneling inside area
Cause 1: