SL 600 (230.477) V12-5.5L Turbo (275.954) (2007)
NOTE: Cut floor covering along dotted lines to avoid time-consuming removal work for heater and air conditioning system.
11
Pull floor covering (6.2) out below instrument panel (5), lift at rear and remove from vehicle
12
Prepare floor covering (6) for installation
CAUTION: Before installing floor covering (6.2) dean passenger compartment in area of floor covering.
NOTE: When replacing floor covering (6.2) cut new floor covering (6) with sharp knife along dotted line and remove section (shaded area)
below heater system.
Install
13
Install floor covering (6.2) in passenger compartment and position
NOTE: Guide cut edges in front area below instrument panel (5) (arrows), simultaneously route wiring harness (7) for passenger seat.
14
Insert A-pillar paneling at bottom right and tighten screw
15
Hook luggage net (8) at right into mounts
16
Install cover below instrument panel (5) (right)
17
Install cover on center console
18
Install stowage box (3)
19
Install belt buckle (2) in right rear
20
Install side paneling (1) in right rear
21
Install front seat on right