SLK 230 (170.449) L4-2.3L SC (111.983) (2001)
Coolant: Procedures
AR20.00-P-1142HG Drain Coolant, Pour In
Drain Coolant, Fill
Shown On Model 202
Lowering
DANGER:
-
Risk of injury to skin and eyes suffering scalding from contact with hot coolant spray, Risk of poisoning from swallowing coolant.
-
Do not open cooling system unless coolant temperature is below 90 degrees C. Open cap slowly and release the pressure. Do not pour
coolant into beverage bottles.
-
Wear protective gloves, protective clothing and eye protection.
1
Open expansion reservoir or cooling system closing cover (2)
NOTE:
-
Closing cover with detent: Rotate cover carefully up to first detent, release pressure relief, then unscrew closing cover.
-
2-stage and 1-stage closing covers: Rotate cover half a revolution counterclockwise, release pressure relief, then unscrew closing cover.
2
Drain coolant at radiator or crankcase
NOTE:
-
Model 163: For draining coolant, remove coolant hose at the bottom of radiator or at coolant pump.
-
Collect coolant
-
Disposal of coolants: observe legal regulations or local waste water requirements!
-
Refer to Environmental Protection Catalog issued by MBVD/PWU for locations in Germany.
Filling system with coolant
NOTE: See notes on coolant.
3
Tighten drain plugs at radiator or crankcase
NOTE: Discharge fitting to crankcase.
4
Pour in coolant
NOTE: See notes on coolant level.