SLK 280 (171.454) V6-3.0L (272.942) (2007)
/v6-3.0l_(272.942)/Page-1920004.png)
Confirmation Screen
Measured values screen for angle 2: e.g. 2.18 degrees
A confirmation message appears briefly.
Confirmation screen
Ready Screen For Angle 3
The display then indicates that the device is ready for the next measurement (angle 3).
4
Remove sensor (020a) from front propeller shaft (1).
Ready screen for angle 3
Component Identification
Measurement - Angle 3: rear propeller shaft
5
Clean contact surfaces for sensor (020a) on rear propeller shaft (2).
6
Position sensor (020a) horizontally on rear propeller shaft (2) and press on firmly.
The spiral cable (020b) of the sensor (020a) must point in the direction of travel for each measurement. Otherwise the measurement will be
inaccurate.
