SLK 320 (170.465) V6-3.2L (112.947) (2002)
Center Support: Removal and Replacement
Removal And Installation Of Propeller Shaft Intermediate Bearing And Replacement Of Grooved Ball Bearing
1
Remove propeller shaft
2
Separate front (1, 1a) and rear propeller shaft (2) at clamp connection or slide connection
NOTE: Installation-Assemble propeller shaft
3
Pull rubber boot (4, 4a) off joint fork
NOTE: Installation: Replace damaged rubber boot and ensure correct fit.
4
Pull off rubber mount (7, 7a) with grooved ball bearing (8) and front protective cap (6)
NOTE:
-
Installation: Press rubber mount with grooved ball bearing onto the joint fork
-
Fit new protective cap on grooved ball bearing.
5
Remove rear protective cap (6a)
NOTE: Installation: Replace protective cap if damaged.
6
Press grooved ball bearing out of rubber mount
NOTE: Installation: Press grooved ball bearing into rubber mount.
7
Check rubber mount and grooved ball bearing for wear
-
Replace parts if necessary.
8
Install in reverse sequence.