mercedesbenz Workshop Repair Guides

Mercedes Benz Workshop Service and Repair Manuals

Body - Roof Seals Noisy on Rough Roads|Page 17312 > < Body - Roof Seals Noisy on Rough Roads|Page 17310
Page 3
background image

Caution! 

Do not place fingers or hands in gap between roof and body.

3.

Drive vehicle again and check if noise is no longer present.

4.

If no longer present, lubricate the roof seals as described in Condition A.

5.

If the noise is still present, the adjustment of the front latches must be checked.

6.

The locking hook (Figure 3, Pos. 2) must be in the center (Figure 3, Pos. 3) of the catch (Figure 3, Pos. 1) when the Vano Roof is locked.

7.

If the locking hook is too low and contacts the catch, this may cause the knocking noise when driving on rough roads.

8.

In this case, add shims at the inner mounting point of the catch until the locking hook is in the center.

9.

If the adjustment does not correct the noise complaint, replace only the latch, reference WIS Document AR77.33-P-3400V.

10.

Apply lubricant paste along the entire length of the catch pin.

11.

Open and close the roof several times, then remove the excess lubricant paste.

Special Tools

Note

This special tool should already be in every dealer's inventory. It was released and automatically delivered to all dealers in February 2002.

Body - Roof Seals Noisy on Rough Roads|Page 17312 > < Body - Roof Seals Noisy on Rough Roads|Page 17310