SLK 350 (171.456) V6-3.5L (272.963) (2006)
e. Hand tighten M8 hex bolt on linkage side.
f. Fasten the M8 hex bolt on the angle bracket side using the M8 self-locking nut provided in the replacement part set (the bolt must be inserted from
below as illustrated in Figure 9).
g. Tighten both M8 hex bolts to 15 Nm.
h. Ensure that the linkage is not obstructed, and is protected by the linkage protection strut (Figure 10).
10. Reinstall seat in vehicle as per WIS document AR91.10-P-1000V
Parts Information
Note:
The following allowable labor operations should be used when submitting a warranty claim for this repair. This information has been generated on June
17, 2009. Please refer to Netstar --> Star TekInfo --> Star Time for the most current labor time allowance.