SLK 55 AMG (171.473) V8-5.5L (113.989) (2005)
Radiator Cooling Fan Motor: All Technical Service Bulletins
Campaign - Engine Cooling Fan Harness Routing
FILE:
SERVICE: GROUP 00 OF SERVICE INFORMATION BINDER
PARTS: GROUP I OF INFORMATION _ PARTS & ACCESSORIES BINDER
Campaign No. 2006010004, March 2006
Revision
Date
Purpose
A
03/15/06
Warranty information: Model Indicator change
-
03/08/06
Initial issue
TO: ALL MERCEDES-BENZ CENTERS
SUBJECT:
MODEL 171 AMG MODEL YEAR 2005
INSPECT ROUTING OF ENGINE FAN WIRING HARNESS AND CORRECT IF NECESSARY
This service campaign has been initiated because DCAG has determined that on the affected vehicles (see VIN range below) the clearance between the
engine fan wiring harness and the engine belt pulley may be less than specified. Dealer will inspect, and if out of tolerance, adjust the clearance between
the engine fan wiring harness and the engine belt pulley.
Please review the Effective Serial Number chart located below, and if necessary, repair the subject vehicles during the vehicle's next service.
Prior to performing this Service Campaign:
^
Please check VMI to insure the vehicle is involved and to determine if the vehicle has been previously repaired.
^
Please review the entire Service Campaign bulletin.
Approximately 48 vehicles are affected.
Effective Serial Number Range
Note:
Every vehicle in the VIN range may not be included in the campaign. VMI must always be checked before performing campaigns to verify that the
campaign is required on a specific vehicle. VMI always overrides the bulletin in reference to a specific vehicle's inclusion in a particular campaign.
Please also note that Recall and Service Campaigns do not expire and may also be performed on a vehicle with a vehicle status indicator.
Procedure
A.
INSPECT ROUTING OF ENGINE FAN WIRING HARNESS
1.
Remove left air intake hose.